The power steering ECU assembly supplies current to the power steering motor assembly through the motor circuit.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Warning Indicate | Return-to-normal Condition | Note |
|---|---|---|---|---|---|---|
| C1524 | Motor Terminal Voltage | Short (or open) in motor circuit or abnormal voltage in motor circuit | ·
Power steering motor assembly ·
Power steering ECU assembly |
EPS warning light: Comes on | Ignition switch ON again | - |
| C1555 | Motor Relay Welding Failure | Predriver (Motor relay circuit) malfunction | ·
Power steering motor assembly ·
Power steering ECU assembly |
EPS warning light: Comes on | Ignition switch ON again | - |
If the power steering ECU assembly has been replaced, perform assist map writing and torque sensor zero point calibration.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM(for TMT Made)>CALIBRATION
Start the engine.
| *a | Component with harness connected
(Power Steering ECU Assembly) |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| z9-1 (M1) - Body ground | Engine running and steering wheel being turned to left | 6 to 11 V |
| z9-1 (M1) - Body ground | Engine running and steering wheel being turned to right | 11 to 14 V |
| z9-2 (M2) - Body ground | Engine running and steering wheel being turned to left | 11 to 14 V |
| z9-2 (M2) - Body ground | Engine running and steering wheel being turned to right | 6 to 11 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the power steering ECU assembly connector.
| *a | Front view of wire harness connector
(to Power Steering ECU Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| z9-1 (M1) - z9-2 (M2) | Always | 0.1 to 1.0 Ω |
| z9-1 (M1) or z9-2 (M2) - Body ground | Always | 1 MΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG