1.PLACE FRONT WHEELS FACING STRAIGHT AHEAD
45130
2.REMOVE HORN BUTTON ASSEMBLY
45100
3.REMOVE STEERING WHEEL ASSEMBLY
55106
4.REMOVE BRAKE PEDAL SUPPORT SUB-ASSEMBLY (for LHD)
55106
5.REMOVE BRAKE PEDAL SUPPORT SUB-ASSEMBLY (for RHD)
45289A
6.REMOVE STEERING COLUMN COVER SUPPORT (w/ Smart Entry and Start System)
Disengage the 4 claws and remove the steering column cover support.
45287
7.REMOVE LOWER STEERING COLUMN COVER
Remove the 3 screws.
Release the tilt lever, disengage the 3 claws and remove the lower steering column cover.
45286B
8.REMOVE UPPER STEERING COLUMN COVER
Disengage the claw and remove the upper steering column cover.
9.REMOVE COMBINATION SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY
Disconnect all the connectors from the combination switch assembly with spiral cable sub-assembly.
| *1 | Clamp |
| *a | Claw |
Use pliers to hold the clamp and raise the claw with a screwdriver. Remove the combination switch assembly with spiral cable sub-assembly from the steering column assembly.
45259A
10.REMOVE COLUMN HOLE COVER SILENCER SHEET
Fold back the floor carpet.
Remove the 2 clips and the column hole cover silencer sheet.
45209
11.SEPARATE STEERING SLIDING YOKE SUB-ASSEMBLY
| *a | Matchmark |
Put matchmarks on the steering sliding yoke sub-assembly and the steering link assembly.
Loosen bolt A.
Remove bolt B and separate the steering sliding yoke sub-assembly from the steering link assembly.
12.REMOVE STEERING COLUMN ASSEMBLY
Disconnect all the connectors and disengage the 2 clamps to separate the wire harness from the steering column assembly.
Do not pull the wire harness.
Disconnect the 2 connectors from the power steering ECU assembly.
Disengage the wire harness clamp to separate the wire harness from the power steering ECU assembly.
Do not pull the wire harness.
Remove the bolt, 2 nuts and the steering column assembly from the instrument panel reinforcement assembly.
45879A
13.REMOVE BREAK AWAY CAPSULE
Remove the 2 break away capsules from the steering column assembly.