When an incorrect ECM or skid control ECU (brake actuator assembly) is installed after the assist map has been written to the power steering ECU assembly, then DTC C1582 is stored because the data does not match the vehicle specifications.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Warning Indicate | Return-to-normal Condition | Note |
|---|---|---|---|---|---|---|
| C1582 | Assist Map Number Mismatch | Assist map number mismatch | ·
CAN communication system ·
Incorrect ECM ·
Incorrect skid control ECU (brake actuator assembly) ·
Power steering ECU assembly |
EPS warning light: Does not come on | Ignition switch ON again | - |
If the power steering ECU assembly has been replaced, perform assist map writing and torque sensor zero point calibration.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM(for TMT Made)>CALIBRATION
Related parts store information necessary for assist map writing.
Related Part:
ECM
Skid control ECU (Brake actuator assembly)
Check for DTCs.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM
| Result | Proceed to |
|---|---|
| CAN communication system DTCs are not output. | A |
| CAN communication system DTCs are output. | B |
A
B
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Check if the parts below has been replaced with an incorrect part in the past.
| Related Part | ECM |
| Skid control ECU (Brake actuator assembly) |
When removing the related part to check it, be sure to follow the appropriate procedures and precautions.
ECM
for 1NR-FE
Click hereEngine / Hybrid System>1NR-FE ENGINE CONTROL>ECM>REMOVAL
for 2NR-FE
Click hereEngine / Hybrid System>2NR-FE ENGINE CONTROL>ECM>REMOVAL
Skid control ECU (Brake actuator assembly)
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR>REMOVAL
When DTC C1582 is output and parts have not been exchanged, replace the power steering ECU assembly as it may have an internal malfunction.
If the power steering ECU assembly has been replaced, perform assist map writing and torque sensor zero point calibration.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM(for TMT Made)>CALIBRATION
| Result | Proceed to |
|---|---|
| Any of the related parts have the incorrect part number. | A |
| All of the related parts have the correct part number, or a related part and power steering ECU assembly have not been replaced. | B |
A
B
Replace the related parts with ones that have the correct part number.
ECM
for 1NR-FE
Click hereEngine / Hybrid System>1NR-FE ENGINE CONTROL>ECM>REMOVAL
for 2NR-FE
Click hereEngine / Hybrid System>2NR-FE ENGINE CONTROL>ECM>REMOVAL
Skid control ECU (Brake actuator assembly)
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM(for TMT Made)>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTCs are not output. | A |
| DTCs are output. | B |
A
B