Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM(for TMMIN Made) › 2017.10–2018.01
RM30M0E _55 Steering _017103 POWER ASSIST SYSTEMS _0333419 POWER STEERING SYSTEM(for TMMIN Made) C

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM(for TMMIN Made)  C1515  Torque Sensor Zero Point Adjustment Undone  C1516  Torque Sensor Zero Point Adjustment Incomplete  


DESCRIPTION

These DTCs do not indicate a malfunction. The power steering ECU assembly stores these DTCs when it determines that rotation angle sensor value initialization and torque sensor zero point calibration have not been performed.

DTC No. Detection Item DTC Detection Condition Trouble Area Return-to-normal Condition Note
C1515 Torque Sensor Zero Point Adjustment Undone Torque sensor zero point calibration has not been performed. There is no malfunction if this DTC is not output again after performing torque sensor zero point calibration. Zero point calibration performed Power Steering Warning Light comes on.
C1516 Torque Sensor Zero Point Adjustment Incomplete Torque sensor zero point calibration is incomplete due to the steering wheel being touched during calibration. There is no malfunction if this DTC is not output again after clearing the DTCs and torque sensor calibration value, and then performing zero point calibration. DTCs cleared Power Steering Warning Light comes on.

CAUTION / NOTICE / HINT

NOTICE:

If the power steering ECU assembly, electric power steering column sub-assembly or power steering motor assembly have been replaced, perform torque sensor zero point calibration.

Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM(for TMMIN Made)>CALIBRATION


PROCEDURE

1.CHECK FOR DTC
a.

Check if DTC C1516 is output.

Chassis > EMPS > Trouble Codes
50001 13
Result:
Result Proceed to
C1516 is output A
C1516 is not output B




A

2.CLEAR DTC

B

3.PERFORM TORQUE SENSOR ZERO POINT CALIBRATION
2.CLEAR DTC
a.

Clear the DTCs.

Chassis > EMPS > Clear DTCs
50002 13

Result:
Proceed to
NEXT



NEXT

3.PERFORM TORQUE SENSOR ZERO POINT CALIBRATION
3.PERFORM TORQUE SENSOR ZERO POINT CALIBRATION
a.

Result:
Proceed to
NEXT



NEXT

4.CHECK FOR DTC
4.CHECK FOR DTC
a.

Check for DTCs.

Chassis > EMPS > Trouble Codes
50001 13
Result:
Condition Proceed to
DTC C1515 or C1516 is still output after performing torque sensor zero point calibration 3 times A
DTC C1515 or C1516 is not output B


NOTICE:

If DTC C1515 or C1516 is output even though torque sensor zero point calibration has been performed, confirm the procedure again and perform calibration 3 times.




A

B

END