Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR AXLE HUB(for Rear Disc Brake) › 2017.10–2018.01
RM30M0E _52 Drivetrain _017093 AXLE AND DIFFERENTIAL _0090090 REAR AXLE HUB(for Rear Disc Brake) A

AXLE AND DIFFERENTIAL  REAR AXLE HUB(for Rear Disc Brake)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 58910C 2.REMOVE REAR CONSOLE BOX ASSEMBLY (for Integrated Type)

Hide 58901A 3.REMOVE REAR CONSOLE BOX ASSEMBLY (for Separate Type)

Hide 4.LOOSEN PARKING BRAKE CABLE

Hide 46430 5.DISCONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY

Hide 6.SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY

Hide 8.DISCONNECT SKID CONTROL SENSOR WIRE

a.
C282356

Using a screwdriver, disengage the claw of the connector lock portion and disconnect the skid control sensor wire connector.


Hide 9.REMOVE REAR AXLE HUB AND BEARING ASSEMBLY

a.
C290891

Remove the 4 bolts and rear axle hub and bearing assembly from the rear axle beam assembly.

NOTICE:
·

Do not place the rear speed sensor side so that it is facing downward, and do not allow the rear speed sensor side to become damaged or contact foreign matter.

·

Do not drop the rear axle hub and bearing assembly.



HINT:

The rear axle hub and bearing assembly is a component of the rear speed sensor.