For vehicles equipped with VSC, if a wheel alignment has been performed, or if suspension or underbody components have been removed/installed or replaced, be sure to perform the following initialization procedure in order for the system to function normally:
Perform zero point calibration of the yaw rate and acceleration sensor.
1.INSPECT TIRES
2.MEASURE VEHICLE HEIGHT (for Sedan)
3.MEASURE VEHICLE HEIGHT (for Hatchback)
4.INSPECT CAMBER
Inspect while the vehicle is unloaded.
Remove the wheel cap or wheel hub ornament.
Install the camber-caster-kingpin gauge and position the rear wheel on the turning radius gauge.
Inspect the camber.
| Camber Inclination | Right-left Difference |
|---|---|
| -0°56' +/- 0°45' (-0.93° +/- 0.75°) | 0°45' (0.75°) or less |
| Camber Inclination | Right-left Difference |
|---|---|
| -0°54' +/- 0°45' (-0.90° +/- 0.75°) | 0°45' (0.75°) or less |
If the camber is not within the specified range, inspect the suspension parts for damage and wear, and replace them if necessary.
Remove the camber-caster-kingpin gauge.
Install the wheel cap or wheel hub ornament.
5.INSPECT TOE-IN
Inspect while the vehicle is unloaded.
Bounce the vehicle up and down at the corners to stabilize the suspension.
Release the parking brake and move the shift lever to neutral.
Push the vehicle straight ahead approximately 5 m (16.4 ft.). (Step A)
| *a | Tread Center Mark |
| *b | Dimension B |
|
Front of the Vehicle |
Put tread center marks on the rearmost points of the rear wheels and measure the distance between the marks (dimension B).
Slowly push the vehicle straight ahead to cause the rear wheels to rotate 180°. Use the rear tire valve as a reference point.
Do not allow the wheels to rotate more than 180°. If the wheels rotate more than 180°, perform the procedure from (Step A) again.
| *a | Dimension A |
|
Front of the Vehicle |
Measure the distance between the tread center marks on the front of the rear wheels (dimension A).
| Tire Size | Specified Condition |
|---|---|
| 175/65R14 | C + D: 0°18' +/- 0°15' (0.30° +/- 0.25°) |
| B - A: 3.1 +/- 3.0 mm (0.122 +/- 0.118 in.) | |
| 185/60R15
195/50R16 |
C + D: 0°18' +/- 0°15' (0.30° +/- 0.25°) |
| B - A: 3.2 +/- 3.0 mm (0.126 +/- 0.118 in.) |
| Tire Size | Specified Condition |
|---|---|
| 175/65R14 | C + D: 0°14' +/- 0°15' (0.23° +/- 0.25°) |
| B - A: 2.5 +/- 3.0 mm (0.0984 +/- 0.118 in.) | |
| 185/60R15 | C + D: 0°14' +/- 0°15' (0.23° +/- 0.25°) |
| B - A: 2.7 +/- 3.0 mm (0.106 +/- 0.118 in.) |
Measure "B - A" only when "C + D" cannot be measured.
If the toe-in is not within the specified range, inspect the suspension parts for damage and wear, and replace them if necessary.