Home › Vehicle Interior › SEAT BELT › FRONT SEAT OUTER BELT ASSEMBLY › 2017.10–2018.01
RM30M0E _58 Vehicle Interior _017117 SEAT BELT _0092579 FRONT SEAT OUTER BELT ASSEMBLY A

SEAT BELT  FRONT SEAT OUTER BELT ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing. (w/ Pretensioner and Force Limiter)

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


HINT:

The procedure described below is for the LH side. Use the same procedure for both the LH and RH sides, unless otherwise specified.


PROCEDURE

Hide 1. PRECAUTION (w/ Pretensioner and Force Limiter)

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Pretensioner and Force Limiter)

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 67913 3.REMOVE FRONT DOOR SCUFF PLATE (for TMT Made)

Hide 62312B 4.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP

a.

Disconnect the front door opening trim weatherstrip to the extent that the center pillar lower garnish and center pillar upper garnish can be removed.


Hide 67917A 5.REMOVE REAR DOOR SCUFF PLATE (for TMT Made)

Hide 62332A 6.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP

a.

Disconnect the rear door opening trim weatherstrip to the extent that the center pillar lower garnish and center pillar upper garnish can be removed.


Hide 73220 7.DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY

a.
B343484

Remove the bolt to disconnect the floor anchor of the front seat outer belt assembly.


Hide 62414A 8.REMOVE CENTER PILLAR LOWER GARNISH

Hide 62412B 9.REMOVE CENTER PILLAR UPPER GARNISH

Hide 73220 10.REMOVE FRONT SEAT OUTER BELT ASSEMBLY

a.

for TMT Made:

i.
B487714

Remove the nut to disconnect the shoulder anchor of the front seat outer belt assembly.



b.

for TMMIN Made:

i.
B343485

Remove the bolt to disconnect the shoulder anchor of the front seat outer belt assembly.



c.
B346960C01
0.844,2.208 0.552,2.208 true 0.927,2.667 1.302,2.792 true 1.354,2.719 1.667,2.99 0.313,0.271 10 false *1 0.385,2.104 0.698,2.385 0.313,0.281 10 false *a
*1 Locking Button
*a Protective Tape


w/ Pretensioner and Force Limiter:

i.

Using a screwdriver with its tip wrapped in protective tape, release the locking button.


ii.

Disconnect the pretensioner connector.



d.
B346961

Remove the 2 bolts.


e.

Disengage the 2 hooks to remove the front seat outer belt assembly.


Hide 73200A 11.REMOVE FRONT SHOULDER BELT ADJUSTER ANCHOR ASSEMBLY (for TMT Made)

a.
B487715

Remove the 2 bolts.


b.

Disengage the guide to remove the front shoulder belt anchor adjuster assembly.