Home › General › INTRODUCTION › REPAIR INSTRUCTION › 2017.10–2018.01
RM30M0E _V1 General _017288 INTRODUCTION _0085515 REPAIR INSTRUCTION D

INTRODUCTION  REPAIR INSTRUCTION  INITIALIZATION  


PROCEDURES NECESSARY WHEN BATTERY TEMINAL IS DISCONNECTED/RECONNECTED


Necessary Procedure Effect/Inoperative Function when Necessary Procedures are not Performed Link
Back door lock (for Hatchback) Power door lock control system (Click here)


PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED


Replacement Part Necessary Procedure Effect/Inoperative Function when Necessary Procedures are not Performed Link
ECM Perform Vehicle Identification Number (VIN) registration MIL comes on for 1NR-FE:
(Click here)
for 2NR-FE:
(Click here)
·

Throttle body with motor assembly

·

Cleaning the deposits from the throttle body with motor assembly

·

Engine assembly

·

Cylinder head sub-assembly

·

Camshaft (for intake or exhaust camshaft)

·

Camshaft timing gear assembly

·

Camshaft timing exhaust gear assembly

·

Piston or piston ring

·

Mass air flow meter

·

Fuel injector assembly

·

Fuel pump

·

Air fuel ratio sensor

·

Engine coolant temperature sensor

·

Spark plug

·

No. 1 ignition coil

·

Air leaks from intake system

·

Gas leaks from exhaust system

·

Knock sensor


Inspection after repair Poor idle, engine start, etc. for 1NR-FE:
(Click here)
for 2NR-FE:
(Click here)
·

Continuously variable transaxle assembly

·

ECM

·

Oil pressure sensor

·

Yaw rate and acceleration sensor (airbag ECU assembly)


·

Reset memory

·

Deceleration sensor zero point calibration

·

CVT oil pressure calibration


Deterioration of fuel efficiency for K312:
(Click here)
for K411:
(Click here)
CVT fluid*1 Perform ATF thermal degradation estimate reset The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly
Skid control ECU (brake actuator assembly)*2 Perform yaw rate and acceleration sensor zero point calibration and store system information
·

VSC disabled or malfunctions

·

DTCs are stored

·

Slip indicator light illuminates

·

ABS warning light illuminates


(Click here)
Yaw rate and acceleration sensor (airbag ECU assembly)*2
·

Clear zero point calibration data and store system information

·

Perform yaw rate and acceleration sensor zero point calibration and store system information


·

Power steering motor assembly

·

Power steering ECU assembly

·

Electric power steering column sub-assembly (containing the torque sensor)


Perform torque sensor zero point calibration
·

DTCs are stored

·

EPS warning light illuminates


for TMT Made:
(Click here)
for TMMIN Made:
(Click here)
ECM ECU communication ID registration (Immobiliser system) Engine start See Service Bulletin for the registration method.
·

Transponder key ECU assembly*3

·

Key*3


Code registration (Immobiliser system) Engine start
·

Certification ECU (smart key ECU assembly)*4

·

Steering lock ECU (steering lock actuator assembly)*4

·

Electrical key transmitter sub-assembly*4


Code registration (Immobiliser system)
·

Wireless door lock control system

·

Smart entry and start system

·

Engine start

·

Steering lock system


·

Door control transmitter assembly*3

·

Door control receiver*3


Code registration (Wireless door lock control system) Wireless door lock control system (Click here)
·

Front door window regulator assembly LH*5, RH*6

·

Front power window regulator motor assembly LH*5, RH*6

·

Door glass

·

Door glass run


Initialize power window control system
·

Auto up and down function

·

Jam protection function


(Click here)
Body ECU*7 Initialize automatic light control system Automatic light control system (Click here)

*1: for TMT Made

*2: w/ VSC

*3: w/o Smart Entry and Start System

*4: w/ Smart Entry and Start System

*5: for LHD

*6: for RHD

*7: w/ Automatic Light Control System