Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › STEERING ANGLE SENSOR › 2017.10–2018.01
RM30M0E _54 Brake _017098 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0262396 STEERING ANGLE SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  STEERING ANGLE SENSOR  INSTALLATION  


PROCEDURE

Hide 84306 1.INSTALL SPIRAL CABLE SUB-ASSEMBLY (for TMMIN Made)

Hide 84306 2.INSTALL SPIRAL CABLE SUB-ASSEMBLY (for TMT Made)

Hide 3.INSTALL STEERING SENSOR (for TMT Made)

a.
C381049C01
2.354,1.229 1.885,0.948 1.885,0.948 2.333,0.729 true 2.802,0.906 3.167,0.521 true 0.281,0.542 0.615,0.896 true 2.063,0.438 2.375,0.563 true 1.688,0.865 2,1.021 0.313,0.156 10 false *a 3.198,0.396 3.427,0.604 0.229,0.208 10 false *b 1.896,0.333 2.208,0.49 0.313,0.156 10 false *c 0.104,0.438 0.333,0.646 0.229,0.208 10 false *b
*a Guide
*b Pin
*c Lock Pin


Align the 2 pins and 2 guides, and engage the 6 claws to install the steering sensor to the spiral cable sub-assembly.

NOTICE:
·

Do not remove the lock pin before the steering sensor is installed to the spiral cable sub-assembly.

·

Do not damage the pins of the spiral cable sub-assembly or guides of the steering sensor.

·

The spiral cable sub-assembly can be rotated up to 30° even when the interlock is engaged. Therefore, make sure that both guides are aligned properly when installing the steering sensor to the spiral cable sub-assembly.




b.
C381050

Remove the lock pin from the steering sensor.