Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
3.REMOVE REAR SEAT ASSEMBLY (for Separate Seat Type)
4.REMOVE REAR SEAT ASSEMBLY (for Fixed Seat Type)
67917A
5.REMOVE REAR DOOR SCUFF PLATE
62331A
6.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP
73360
7.SEPARATE REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY
62551F
8.REMOVE REAR SEAT SIDE GARNISH RH
89860B
9.REMOVE NO. 2 SIDE AIRBAG SENSOR ASSEMBLY
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
Disconnect the connector from the No. 2 side airbag sensor assembly.
When disconnecting any airbag connector, take care not to damage the airbag wire harness.
Push and hold the white housing lock, and slide the yellow outer connector locking sleeve.
| *1 | Housing Lock | *2 | Outer Connector Locking Sleeve |
| *a | Slide | - | - |
Push and hold the white housing lock again, and slide the yellow outer connector locking sleeve to disconnect the connector.
Remove the nut and No. 2 side airbag sensor assembly.
Loosen the nut while holding the No. 2 side airbag sensor assembly because the No. 2 side airbag sensor assembly pin (stopper) is easily damaged.