Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
If the side airbag was deployed, replace the front seat airbag assembly, separate type front seatback spring assembly, separate type front seatback cover and separate type front seatback pad with a new one.
Wear protective gloves. Sharp areas on the parts may injure your hands.
The procedure described below is for the driver side. Use the same procedure for both the driver and front passenger sides, unless otherwise specified.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
73240
3.REMOVE FRONT SEAT INNER BELT ASSEMBLY
71910A
4.REMOVE FRONT SEAT HEADREST ASSEMBLY
72526A
5.REMOVE RECLINING ADJUSTER RELEASE HANDLE
72495
6.REMOVE VERTICAL ADJUSTING HANDLE (w/ Vertical Adjuster)
71812D
7.REMOVE FRONT SEAT CUSHION SHIELD LH
71862
8.REMOVE FRONT SEAT CUSHION INNER SHIELD (for Driver Side)
71862
9.REMOVE FRONT SEAT CUSHION INNER SHIELD (for Front Passenger Side)
10.REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD
11.REMOVE FRONT SEAT SIDE AIRBAG ASSEMBLY
for LH Side:
Disengage the 4 clamps.
Disengage the claw.
for RH Side:
Disengage the 2 clamps.
Disengage the claw.
Disengage the loop fastener.
Disengage the 2 clamps to separate the front seat side airbag wire harness.
Remove the 2 nuts and front seat side airbag assembly.
The nuts must not be reused.
Make sure that the seat frame assembly is not deformed. If it is, replace it with a new one.