Use the same procedure for LHD and RHD vehicles.
The procedure listed below is for the LHD vehicles.
74210
1.REMOVE FRONT ARMREST ASSEMBLY RH
Use the same procedure as for the LH side.
Click hereVehicle Exterior>DOOR / HATCH>FRONT DOOR(for TMT Made)>DISASSEMBLY
74231
2.REMOVE FRONT ARMREST BASE UPPER PANEL RH
Use the same procedure as for the LH side.
Click hereVehicle Exterior>DOOR / HATCH>FRONT DOOR(for TMT Made)>DISASSEMBLY
84810
3.REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY
| *a | Protective Tape |
Using a screwdriver with its tip wrapped in protective tape, disengage the 3 claws to remove the power window regulator switch assembly.