Home › Vehicle Exterior › WINDOW / GLASS › WINDOW DEFOGGER SWITCH(for TMT Made) › 2017.10–2018.01
RM30M0E _59 Vehicle Exterior _017121 WINDOW / GLASS _0334618 WINDOW DEFOGGER SWITCH(for TMT Made) A

WINDOW / GLASS  WINDOW DEFOGGER SWITCH(for TMT Made)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for LHD and RHD vehicles.

·

The procedure listed below is for the LHD vehicles.



PROCEDURE

Hide 55909C 1.INSTALL AIR MIX DAMPER CONTROL CABLE SUB-ASSEMBLY

a.
B487225

Engage the claw.


b.
B487226

Install the inner cable end of the air mix damper control cable sub-assembly as shown in the illustration.


c.
B487227

Engage the clamp to install the air mix damper control cable sub-assembly as shown in the illustration.


Hide 55906A 2.INSTALL DEFROSTER DAMPER CONTROL CABLE SUB-ASSEMBLY

a.
B487210

Engage the claw.


b.
B487211

Install the inner cable end of the defroster damper control cable sub-assembly as shown in the illustration.


c.
B487212

Engage the clamp to install the defroster damper control cable sub-assembly as shown in the illustration.


Hide 55900A 3.INSTALL HEATER CONTROL AND ACCESSORY ASSEMBLY

a.

Connect the 2 connectors and engage the 2 clamps to install the heater control and accessory assembly.


b.

Engage the 3 claws to connect the heater control and accessory assembly.


c.
B487213

Engage the claw and clamp to connect the defroster damper control cable sub-assembly as shown in the illustration.


d.
B487606

Engage the claw and clamp to connect the air mix damper control cable sub-assembly as shown in the illustration.


Hide 45287 5.INSTALL LOWER STEERING COLUMN COVER

Hide 73900 6.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Knee Airbag)

Hide 55606 7.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/o Knee Airbag)

Hide 86120 8.INSTALL RADIO RECEIVER ASSEMBLY WITH BRACKET (w/ Radio Receiver)

Hide 55412D 9.INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL (w/o Radio Receiver)

Hide 55046A 10.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH

Hide 55045A 11.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.