Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › ULTRASONIC SENSOR(for Rear) › from 2017.10
RM30M0E _56 Audio / Visual / Telematics _068680 PARK ASSIST / MONITORING _0335045 ULTRASONIC SENSOR(for Rear) A

PARK ASSIST / MONITORING  ULTRASONIC SENSOR(for Rear)  INSTALLATION  


PROCEDURE

Hide 89348S 1.INSTALL REAR CENTER ULTRASONIC SENSOR RETAINER

HINT:
·

Perform this procedure only when replacement of the rear center ultrasonic sensor retainer is necessary.

·

If a rear center ultrasonic sensor retainer has been removed, replace it with a new one.



a.

Clean the surface of the rear bumper assembly.

i.

Remove any remaining double-sided tape from the rear bumper assembly.


ii.

Wipe off any adhesive residue with cleaner.



b.
E335575C01
1.719,1.125 1.938,1.292 0.219,0.167 10 true *a
*a 18 mm (0.71 in.)


Cover the 2 sensor installation holes with an 18 mm (0.71 in.) circular piece of tape.


c.
E372473C01
0.823,1 1.073,1.229 false 0,0 0.313,0.156 0.313,0.156 10 false *a 0,0 0.313,0.156 0.313,0.156 10 false *a 0.656,0.823 0.969,1.021 0.313,0.198 10 false *a
*a Line
V100145

Primer


Using a brush or felt, apply primer or equivalent to the 2 rear center ultrasonic sensor retainers installation area.

NOTICE:
·

Use a clean brush or felt.

·

If primer adheres, it may leave faint stains, so when using a liquid type primer, protect the painted areas with tape.

·

Do not touch the rear bumper assembly until the primer has dried.



Suggested Drying Time:

60 seconds or more



d.

Peel off the release paper from the rear center ultrasonic sensor retainer.


e.
E372474C01
0.854,0.958 1.094,1.198 false 0,0 0.313,0.198 0.313,0.198 10 false *a 0,0 0.313,0.198 0.313,0.198 10 false *a 0.635,0.781 0.948,0.979 0.313,0.198 10 false *a
*a Line
V100155

Press area


Align the rear center ultrasonic sensor retainer with the mark on the rear bumper assembly and install it as shown in the illustration.

NOTICE:

The double-sided tape of a rear center ultrasonic sensor retainer will deteriorate if it is detached. Make sure to use a new rear center ultrasonic sensor retainer when reattachment is necessary.


HINT:

Force of 30 N (3.0 kgf) for 3 seconds to securely install the rear center ultrasonic sensor retainer to the rear bumper cover. Confirm there is no clearance between the rear center ultrasonic sensor retainer and rear bumper cover.



Hide 89342A 2.INSTALL REAR CENTER ULTRASONIC SENSOR

HINT:

Use the same procedure for each rear center ultrasonic sensor.


a.

Engage the 2 claws to install the rear center ultrasonic sensor.


Hide 89348D 3.INSTALL ULTRASONIC SENSOR CLIP

HINT:

Use the same procedure for each ultrasonic sensor clip.


a.

Engage the claw to install the ultrasonic sensor clip.


b.

Connect the connector.


c.

Engage the clamp.


Hide 5.INSTALL REAR BUMPER ASSEMBLY (for Hatchback)