Home › Audio / Visual / Telematics › AUDIO / VIDEO › FRONT DOOR SPEAKER(for TMT Made) › 2017.10–2018.01
RM30M0E _56 Audio / Visual / Telematics _017106 AUDIO / VIDEO _0335087 FRONT DOOR SPEAKER(for TMT Made) A

AUDIO / VIDEO  FRONT DOOR SPEAKER(for TMT Made)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for both the LH and RH sides.

·

The procedure described below is for the LH side.



PROCEDURE

Hide 67492A 1.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH

Hide 74210 2.REMOVE FRONT ARMREST ASSEMBLY

Hide 74232 3.REMOVE FRONT ARMREST BASE UPPER PANEL

Hide 67602 4.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

Hide 86160 5.REMOVE FRONT NO. 1 SPEAKER ASSEMBLY

a.
E290820

Disconnect the connector.


b.

Using a drill bit with a diameter of less than 5 mm (0.197 in.), remove the 3 rivet heads as shown in the illustration.

NOTICE:
·

Do not touch the cone part of the front No. 1 speaker assembly.


·

Do not drill the rivet at an angle as this will cause damage to the drill and drill hole. Line up the drill and rivet, and carefully drill out the rivet head.


·

Be careful as the cut rivet will be very hot.




c.

Continue drilling and push out the remaining rivet fragments.


d.

Disengage the claw and guide to remove the front No. 1 speaker assembly.


e.

Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.