Use the same procedure for both the LH and RH sides.
The procedure described below is for the LH side.
86160B
1.INSTALL REAR SPEAKER ASSEMBLY
Engage the guide and claw to temporarily install the rear speaker assembly.
Using an air riveter or a hand riveter, install the rear speaker assembly with 3 new rivets.
Install the rivets in the order shown in the illustration.
Do not touch the cone part of the rear speaker assembly.
| *1 | Mandrel |
| *a | Riveter |
| *b | Incorrect |
| *c | Correct |
Do not pry on the rivets with the riveter, as this will cause damage to the riveter and mandrel.
| *a | Riveter |
| *b | Incorrect |
| *c | Correct |
Confirm that the rivets are seated properly against the rear speaker assembly.
Do not tilt the riveter when installing the rivets to the rear speaker assembly.
Do not leave any clearance between the rivet heads and rear speaker assembly.
| *a | Riveter |
| *b | Incorrect |
| *c | Correct |
Do not leave any clearance between the rear speaker assembly and door. Firmly hold the 2 items together while installing the rivets.
Connect the connector.
67604
2.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY
69260E
3.INSTALL REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)
74271A
4.INSTALL REAR DOOR ARMREST BASE UPPER PANEL (w/ Power Window)
74271A
5.INSTALL REAR DOOR ARMREST BASE UPPER PANEL (w/o Power Window)
74250
6.INSTALL REAR ARMREST ASSEMBLY (w/ Power Window)
74250
7.INSTALL REAR ARMREST ASSEMBLY (w/o Power Window)