Home › Power Source / Network › POWER DISTRIBUTION › MAIN BODY ECU(for TMMIN Made) › 2017.10–2018.01
RM30M0E _57 Power Source / Network _017109 POWER DISTRIBUTION _0335243 MAIN BODY ECU(for TMMIN Made) A

POWER DISTRIBUTION  MAIN BODY ECU(for TMMIN Made)  INSTALLATION  


PROCEDURE

Hide 89221B 1.INSTALL BODY COMPUTER

NOTICE:
·

Make sure that there is no foreign matter on the contact surfaces or connectors.

·

Make sure that there is no contamination by foreign matter.



a.
B341251

Vertically align the 4 guides on the driver side junction block assembly side with those on the body computer side.


b.

While following the guides, slide the body computer vertically in the direction indicated by the arrow to engage the 4 guides.


c.
B341252C01
2.542,0.698 2.885,0.302 true 2.875,0.094 3.188,0.25 0.313,0.156 10 false *a
*a Push Area


Press the push area of the body computer with the palm of one hand to engage the body computer lock and driver side junction block assembly lock.

When the 2 claws of the locks engage, check that a clicking sound can be heard.

NOTICE:
·

Press the push area of the body computer with the palm of one hand.

·

Check that a clicking sound can be heard.




d.
B341253C01
2.219,0.823 2.646,0.469 true 2.417,0.719 2.771,0.844 2.771,0.844 2.646,1.063 true 1.333,1.177 0.333,0.813 0.333,0.813 1.094,0.823 true 0.177,0.719 0.49,0.875 0.313,0.156 10 false *a 2.677,0.375 2.99,0.531 0.313,0.156 10 false *b 2.813,0.74 3.125,0.896 0.313,0.156 10 false *a
*a Driver Side Junction Block Assembly Enclosing Wall
*b Body Computer Rear Surface


Check that the body computer rear surface and driver side junction block assembly enclosing wall are at the same height.

HINT:
B341257C01
0.042,0.042 0.354,0.24 0.313,0.198 10 false *a 1.104,0.125 1.417,0.323 0.313,0.198 10 false *b 1.073,1.156 1.385,1.354 0.313,0.198 10 false *c
*a Upper view of Body Computer
*b Correct
*c Incorrect


When the lock is engaged correctly, the tip of the body computer lock and body computer lock engagement confirmation rib are in a straight line.



Hide 82730A 2.INSTALL DRIVER SIDE JUNCTION BLOCK ASSEMBLY

a.

Connect the 8 connectors on the back side.


b.

Install the driver side junction block assembly with the 2 bolts.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


c.

Connect the 8 connectors on the front side.


Hide 82817H 3.INSTALL WIRING HARNESS PROTECTOR

a.

Engage the 2 clamps to install the wiring harness protector.


Hide 55301 4.INSTALL INSTRUMENT PANEL SUB-ASSEMBLY