Home › Vehicle Interior › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM(w/ Smart Entry and Start System) › from 2017.10
RM30M0E _58 Vehicle Interior _017110 DOOR LOCK _0091389 WIRELESS DOOR LOCK CONTROL SYSTEM(w/ Smart Entry and Start System) L

DOOR LOCK  WIRELESS DOOR LOCK CONTROL SYSTEM(w/ Smart Entry and Start System)  PRECAUTION  


PRECAUTIONS WHEN USING GTS


a.

When using the GTS with the vehicle engine switch off, connect the GTS to the vehicle and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select the Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Entry&Start(CAN). While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.


b.

After all DTCs are cleared, check if the malfunction occurs again 6 seconds after the engine switch is turned on (IG).



PRECAUTION WHEN REPLACING BODY COMPUTER (w/ Door Control Battery)


a.

As the door control battery is installed between the vehicle battery and body computer, first perform the inspections to confirm that there are no malfunctions in the power source circuit for the body computer before performing this troubleshooting procedure.

Click hereVehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>Power Source Circuit


b.

If the fuse D/L NO. 1 fuse (the main power source fuse of the body computer) is removed with the door control battery charged, power will be supplied to the body computer from the door control battery for up to 30 minutes. At this time, the body computer will be able to function with the fuse D/L NO. 1 fuse (the main power source fuse of the body computer) removed.