Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM › from 2017.10
RM30M0E _56 Audio / Visual / Telematics _068680 PARK ASSIST / MONITORING _0335855 TOYOTA PARKING ASSIST-SENSOR SYSTEM J

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM  Back Sonar Sensor Circuit  


DESCRIPTION

This circuit consists of the sensor power supply, sensor ground and sensor signal wires between the clearance warning ECU assembly and rear center ultrasonic sensors. The rear center ultrasonic sensors are digital sensors.

WIRING DIAGRAM

E318096E07
3.885,0.625 4.344,0.823 0.458,0.198 10 false BI 5.833,0.927 6.292,1.125 0.458,0.198 10 false SOR 5.833,1.25 6.292,1.448 0.458,0.198 10 false E1 5.833,0.604 6.292,0.802 0.458,0.198 10 false BOR 3.896,0.948 4.354,1.146 0.458,0.198 10 false SI 3.896,1.271 4.354,1.469 0.458,0.198 10 false EI 1.229,0.635 1.688,0.833 0.458,0.198 10 false BI 1.219,0.938 1.677,1.135 0.458,0.198 10 false SI 1.219,1.271 1.677,1.469 0.458,0.198 10 false EI 3.177,0.615 3.635,0.813 0.458,0.198 10 false BO 3.177,0.938 3.635,1.135 0.458,0.198 10 false SO 3.177,1.26 3.635,1.458 0.458,0.198 10 false EO 5.552,2.052 7.052,2.469 1.5,0.417 10 false Clearance Warning ECU Assembly 5.552,1.885 6.01,2.083 0.458,0.198 10 false F176 2.938,1.656 3.396,1.854 0.458,0.198 10 false V1 0.26,1.854 1.667,2.427 1.406,0.573 10 false Rear Center Ultrasonic Sensor (RH) 0.26,1.667 0.719,1.865 0.458,0.198 10 false V2 2.927,1.833 4.344,2.417 1.417,0.583 10 false Rear Center Ultrasonic Sensor (LH) 5.563,0.51 6.021,0.708 0.458,0.198 10 false 12 5.563,0.833 6.021,1.031 0.458,0.198 10 false 14 5.573,1.156 6.031,1.354 0.458,0.198 10 false 13 4.156,0.51 4.615,0.708 0.458,0.198 10 false 1 4.167,0.833 4.625,1.031 0.458,0.198 10 false 3 4.177,1.156 4.635,1.354 0.458,0.198 10 false 5 2.969,0.51 3.427,0.708 0.458,0.198 10 false 2 2.969,0.833 3.427,1.031 0.458,0.198 10 false 4 2.969,1.156 3.427,1.354 0.458,0.198 10 false 6 1.479,0.51 1.938,0.708 0.458,0.198 10 false 1 1.5,0.833 1.958,1.031 0.458,0.198 10 false 3 1.51,1.156 1.969,1.354 0.458,0.198 10 false 5

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY - REAR CENTER ULTRASONIC SENSOR (LH))
a.

Disconnect the F176 clearance warning ECU assembly connector.


b.

Disconnect the V1 rear center ultrasonic sensor (LH) connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F176-12 (BOR) - V1-1 (BI) Always Below 1 Ω
F176-14 (SOR) - V1-3 (SI) Always Below 1 Ω
F176-13 (E1) - V1-5 (EI) Always Below 1 Ω
F176-12 (BOR) or V1-1 (BI) - Body ground Always 10 kΩ or higher
F176-14 (SOR) or V1-3 (SI) - Body ground Always 10 kΩ or higher
F176-13 (E1) or V1-5 (EI) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (REAR CENTER ULTRASONIC SENSOR (LH) - REAR CENTER ULTRASONIC SENSOR (RH))

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK HARNESS AND CONNECTOR (REAR CENTER ULTRASONIC SENSOR (LH) - REAR CENTER ULTRASONIC SENSOR (RH))
a.

Disconnect the V1 rear center ultrasonic sensor (LH) connector.


b.

Disconnect the V2 rear center ultrasonic sensor (RH) connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
V1-2 (BO) - V2-1 (BI) Always Below 1 Ω
V1-4 (SO) - V2-3 (SI) Always Below 1 Ω
V1-6 (EO) - V2-5 (EI) Always Below 1 Ω
V1-2 (BO) or V2-1 (BI) - Body ground Always 10 kΩ or higher
V1-4 (SO) or V2-3 (SI) - Body ground Always 10 kΩ or higher
V1-6 (EO) or V2-5 (EI) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

3.INSPECT REAR CENTER ULTRASONIC SENSOR (LH, RH)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.INSPECT REAR CENTER ULTRASONIC SENSOR (LH, RH)


Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG