Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › ULTRASONIC SENSOR(for Rear) › from 2017.10
RM30M0E _56 Audio / Visual / Telematics _068680 PARK ASSIST / MONITORING _0335045 ULTRASONIC SENSOR(for Rear) A

PARK ASSIST / MONITORING  ULTRASONIC SENSOR(for Rear)  REMOVAL  


PROCEDURE

Hide 2.REMOVE REAR BUMPER ASSEMBLY (for Hatchback)

Hide 89348D 3.REMOVE ULTRASONIC SENSOR CLIP

HINT:

Use the same procedure for each ultrasonic sensor clip.


a.
E372470

Using a clip remover, disengage the clamp.


b.

Disconnect the connector.


c.
E372469C01
2.281,1.323 2.958,1.198 true 3.031,1.094 3.344,1.25 0.313,0.156 10 false *a
*a Protective Tape


Using a screwdriver with its tip wrapped in protective tape, disengage the claw to remove the ultrasonic sensor clip.


Hide 89342A 4.REMOVE REAR CENTER ULTRASONIC SENSOR

HINT:

Use the same procedure for each rear center ultrasonic sensor.


a.
E372471

Disengage the 2 claws and remove the rear center ultrasonic sensor.


Hide 89348S 5.REMOVE REAR CENTER ULTRASONIC SENSOR RETAINER

HINT:
·

Perform this procedure only when replacement of the rear center ultrasonic sensor retainers.

·

When removing the rear center ultrasonic sensor retainer, heat the rear bumper assembly and rear center ultrasonic sensor retainer using a heat light.



a.

Heat the rear bumper assembly and rear center ultrasonic sensor retainer using a heat light at the specified temperature for 3 to 5 minutes.

Heating Temperature:
Item Temperature
Rear Bumper Assembly 40 to 60°C (104 to 140°F)
Rear Center Ultrasonic Sensor Retainer


CAUTION:
·

Do not touch the heat light and heated parts.

·

Touching the heat light may result in burns.

·

Touching heated parts for a long time may result in burns.




b.
E372472

Remove the rear center ultrasonic sensor retainer.