Use the same procedure for both the RH and LH sides.
The procedure described below is for the LH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (for Hatchback).
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
74260
3.REMOVE REAR ARMREST ASSEMBLY (w/o Power Window)
74260
4.REMOVE REAR ARMREST ASSEMBLY (w/ Power Window)
69260E
5.REMOVE REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)
74272A
6.REMOVE REAR DOOR ARMREST BASE UPPER PANEL (w/o Power Window)
74272A
7.REMOVE REAR DOOR ARMREST BASE UPPER PANEL (w/ Power Window)
67604
8.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY
68174A
9.REMOVE REAR DOOR GLASS INNER WEATHERSTRIP
68152C
10.REMOVE REAR DOOR GLASS RUN
67842E
11.REMOVE REAR DOOR SERVICE HOLE COVER
67872
12.DISCONNECT REAR DOOR WEATHERSTRIP
Disconnect the upper part of rear door weatherstrip.
67408H
13.REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY
68104
14.REMOVE REAR DOOR GLASS SUB-ASSEMBLY
69340
15.REMOVE REAR DOOR LOCK ASSEMBLY
Using a T30 "TORX" socket wrench, remove the 3 screws.
Move the rear door lock assembly downward and pull the release plate out of the rear door outside handle frame sub-assembly.
When reusing the rear door lock assembly:
Remove the door lock wiring harness seal from the rear door lock assembly.
69780B
16.REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY
Disengage the 3 claws and open the cover in the direction indicated by the arrow as shown in the illustration.
Disengage the guide and remove the rear door inside locking cable assembly from the rear door lock assembly.
69740D
17.REMOVE REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY
Disengage the 2 claws and open the cover in the direction indicated by the arrow as shown in the illustration.
Disengage the guide and remove the rear door lock remote control cable assembly from the rear door lock assembly.