Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › IMMOBILISER SYSTEM(w/ Smart Entry and Start System) › 2017.10–2018.01
RM30M0E _58 Vehicle Interior _017111 THEFT DETERRENT / KEYLESS ENTRY _0090851 IMMOBILISER SYSTEM(w/ Smart Entry and Start System) T

THEFT DETERRENT / KEYLESS ENTRY  IMMOBILISER SYSTEM(w/ Smart Entry and Start System)  PROBLEM SYMPTOMS TABLE  


HINT:
·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.

·

If the problem only occurs in certain locations or at certain times of day, check for wave interference.

·

If the vehicle components are added, check for wave interference from the added components.



Immobiliser System (w/ Smart Entry and Start System)
Symptom Suspected Area Link
Security indicator light does not blink Proceed to "Security Indicator Light Does not Blink" Click here
Engine cannot be started*1 Certification ECU (smart key ECU assembly) -
ECM -
SFI system -
Power source mode cannot be changed*1 Engine switch Click here
Certification ECU (smart key ECU assembly) -
Steering lock lock/unlock not possible*2 Steering lock ECU (steering lock actuator assembly) Click here
Immobiliser system does not operate properly Proceed to "Immobiliser System does not Operate Properly" Click here

*1: Refer to Problem Symptoms Table for Smart Entry and Start System (for Start Function).

*2: Refer to Problem Symptoms Table for Steering Lock System.