Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR BUMPER(for Sedan with Rear Light) › 2017.10–2018.01
RM30M0E _59 Vehicle Exterior _017128 EXTERIOR PANELS / TRIM _0336520 REAR BUMPER(for Sedan with Rear Light) A

EXTERIOR PANELS / TRIM  REAR BUMPER(for Sedan with Rear Light)  REASSEMBLY  


PROCEDURE

Hide 89348S 1.INSTALL REAR CENTER ULTRASONIC SENSOR RETAINER (w/ Clearance Sonar System)

Hide 89342A 2.INSTALL REAR CENTER ULTRASONIC SENSOR (w/ Clearance Sonar System)

Hide 89348D 3.INSTALL ULTRASONIC SENSOR CLIP (w/ Clearance Sonar System)

Hide 82182 4.INSTALL NO. 2 LUGGAGE ROOM WIRE (w/ Clearance Sonar System)

a.
E372470

Connect the connector and engage the clamp.

HINT:

Use the same procedures for the opposite side.



b.

Install the No. 2 luggage room wire.


Hide 52462 5.INSTALL REAR BUMPER PAD RH

a.
B484289C01
1.865,1.104 2.094,0.958 false 2.146,0.854 2.458,1.052 0.313,0.198 10 false *a
*a Location Line


Install the new rear bumper pad RH.

HINT:

Install the rear bumper pad RH along the location line on the rear bumper.



Hide 75895N 6.INSTALL NO. 1 MOULDING TAPE

a.
B484287C01
1.104,1.198 1.427,1.979 true 1.479,1.906 1.792,2.104 0.313,0.198 10 false *a
*a Location Line


Install the new No.1 moulding tape as shown in the illustration.

HINT:

Install the No.1 moulding tape along the location line on the rear bumper.



Hide 52563A 7.INSTALL REAR BUMPER UPPER RETAINER LH

a.
B484288

Install the rear bumper upper retainer LH with the screw.


Hide 52562B 8.INSTALL REAR BUMPER UPPER RETAINER RH

HINT:

Use the same procedure as for the LH side.


Hide 81550 10.INSTALL REAR COMBINATION LIGHT ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.


Hide 52023 11.INSTALL REAR BUMPER REINFORCEMENT SUB-ASSEMBLY

a.
B484286

Engage the 2 guides to install the rear bumper reinforcement sub-assembly.


b.

Install the 2 bolts.

Torque:
19 N*m (194 kgf*cm, 14 ft.*lbf)


Hide 52576 12.INSTALL REAR BUMPER SIDE RETAINER LH

a.
B484285

Engage the 5 claws to install the rear bumper side retainer LH.


b.

Install the screw grommet.


c.

Install the 2 screws.


Hide 52575 13.INSTALL REAR BUMPER SIDE RETAINER RH

HINT:

Use the same procedure as for the LH side.


Hide 81920 14.INSTALL REFLEX REFLECTOR ASSEMBLY LH (w/o Rear Fog Light)

a.
B484284

Engage the guide and install the reflex reflector assembly LH.


b.

Install the 2 screws.


Hide 81910 15.INSTALL REFLEX REFLECTOR ASSEMBLY RH (w/o Rear Fog Light)

HINT:

Use the same procedure as for the LH side.


Hide 81590B 16.INSTALL REAR FOG LIGHT ASSEMBLY LH (w/ Rear Fog Light)

Hide 81580H 17.INSTALL REAR FOG LIGHT ASSEMBLY RH (w/ Rear Fog Light)

HINT:

Use the same procedure as for the LH side.