| *a | Centering Bolt |
| *b | Standard Bolt |
Centering bolts are used to mount the door hinge to the door. The door cannot be adjusted with the centering bolts installed. Substitute the centering bolts with standard bolts when making adjustments.
Specified torque for standard bolts is shown in the standard bolt chart.
Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS
64401
1.INSPECT LUGGAGE COMPARTMENT DOOR PANEL SUB-ASSEMBLY
Check that the clearance measurements are within the standard ranges.
| Area | Measurement | Area | Measurement |
|---|---|---|---|
| A | 8.0 mm (0.315 in.) | B | 11.9 mm (0.469 in.) |
| C | 2.8 to 5.8 mm (0.111 to 0.228 in.) | D | 6.4 to 10.4 mm (0.252 to 0.409 in.) |
| E | 5.1 to 9.1 mm (0.201 to 0.358 in.) | F | 3.7 to 7.7 mm (0.146 to 0.303 in.) |
64711
2.REMOVE LUGGAGE COMPARTMENT FLOOR MAT
64770
3.REMOVE SPARE WHEEL COVER ASSEMBLY
58387
4.REMOVE REAR FLOOR FINISH PLATE
64401
5.ADJUST LUGGAGE COMPARTMENT DOOR PANEL SUB-ASSEMBLY
Adjust the door position.
Horizontally and vertically adjust the door by loosening the 4 luggage compartment door side hinge bolts.
Tighten the 4 luggage compartment door side hinge bolts after the adjustment.
Adjust the striker position.
Using a T40 "TORX" socket wrench, slightly loosen the 2 striker mounting screws.
Using a plastic-faced hammer, hit the striker to adjust its position.
Using a T40 "TORX" socket wrench, tighten the 2 striker mounting screws after the adjustment.
58387
6.INSTALL REAR FLOOR FINISH PLATE
64770
7.INSTALL SPARE WHEEL COVER ASSEMBLY
64711
8.INSTALL LUGGAGE COMPARTMENT FLOOR MAT