Home › Vehicle Interior › HEATING / AIR CONDITIONING › FRONT EVAPORATOR TEMPERATURE SENSOR(for TMMIN Made) › 2017.10–2018.01
RM30M0E _58 Vehicle Interior _017118 HEATING / AIR CONDITIONING _0336790 FRONT EVAPORATOR TEMPERATURE SENSOR(for TMMIN Made) A

HEATING / AIR CONDITIONING  FRONT EVAPORATOR TEMPERATURE SENSOR(for TMMIN Made)  INSTALLATION  


PROCEDURE

Hide 88625 1.INSTALL NO. 1 COOLER THERMISTOR

a.
I109785C01
1.604,2.427 1.802,2.573 true 2.052,1.385 1.885,1.573 true 2.594,1.01 2.26,0.99 true 3.052,0.708 3.365,0.906 0.313,0.198 10 true a 3.042,0.302 3.354,0.5 0.313,0.198 10 true b 3.01,1.448 3.323,1.646 0.313,0.198 10 true c 1.156,0.729 1.375,0.906 0.219,0.177 10 true *a 1.646,1.583 1.865,1.76 0.219,0.177 10 true *b 2.625,0.927 2.844,1.104 0.219,0.177 10 true *c 1.938,2.229 2.156,2.406 0.219,0.177 10 true *d 1.458,2.281 1.677,2.458 0.219,0.177 10 true *e 1.385,2.896 1.604,3.073 0.219,0.177 10 true *1
*1 No. 1 Cooler Evaporator Sub-assembly
*a from Tank
*b Fixed Part
*c Sensor Part
*d Next to Previous
*e Plastic Case


Install the No. 1 cooler thermistor as shown in the illustration.

Installation Position:
Mark Measurement
a 47.7 mm (1.88 in.)
b 34.3 mm (1.35 in.)
c 48 to 52 mm (1.89 to 2.05 in.)


NOTICE:
·

Be sure to insert the thermistor only once because reinserting it into the same position will not allow it to be firmly secured.

·

When reusing the evaporator, insert the thermistor one row next to the one that [was] used previously (*d in the illustration).

·

After inserting the thermistor, do not apply excessive force to the wire.

·

Directly insert the thermistor until the edge of the plastic case "*e" comes into contact with the evaporator "*1".




Hide 88501 2.INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY

Hide 87010 4.INSTALL AIR CONDITIONING UNIT ASSEMBLY