Use the same procedure for the RH and LH sides.
The procedure described below is for the LH side.
64740C
1.INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH
64716D
2.INSTALL REAR DECK TRIM COVER
3.INSTALL REAR SEAT ASSEMBLY (for Separate Seat Type)
64773B
4.INSTALL NO. 2 SPARE WHEEL COVER PAD
58410B
5.INSTALL DECK BOARD ASSEMBLY
64711E
6.INSTALL LUGGAGE COMPARTMENT FLOOR MAT
64330
7.INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY
81560
8.INSTALL REAR COMBINATION LIGHT ASSEMBLY
for Bulb Type Stop Light:
Turn the instrument panel wire with the rear turn signal light bulb and tail and stop light bulb in the direction indicated by the arrow shown in the illustration to install them.
Engage the clip and pin to install the rear combination light assembly.
Install the 2 screws.
Install the grommet.
Connect the connector.