Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR AXLE HUB(for Rear Drum Brake) › from 2017.10
RM30M0E _52 Drivetrain _017093 AXLE AND DIFFERENTIAL _0090092 REAR AXLE HUB(for Rear Drum Brake) G

AXLE AND DIFFERENTIAL  REAR AXLE HUB(for Rear Drum Brake)  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 42403 2.REMOVE REAR BRAKE DRUM SUB-ASSEMBLY

Hide 3.INSPECT REAR AXLE HUB BEARING LOOSENESS

a.
C283826

Using a dial indicator, check for looseness near the center of the rear axle hub and bearing assembly.

Maximum looseness:

0.05 mm (0.00197 in.)


NOTICE:
·

Ensure that the dial indicator is set perpendicular to the measurement surface.

·

Keep the magnet of the dial indicator away from the rear speed sensor.



If the looseness is more than the maximum, replace the rear axle hub and bearing assembly.


Hide 4.INSPECT REAR AXLE HUB RUNOUT

a.
C283827

Using a dial indicator, check for runout on the surface of the rear axle hub and bearing assembly outside the rear axle hub bolt.

Maximum runout:

0.07 mm (0.00276 in.)


NOTICE:
·

Ensure that the dial indicator is set perpendicular to the measurement surface.

·

Make sure to set the tip of the dial indicator towards the outside of the rear axle hub bolts.

·

Keep the magnet of the dial indicator away from the rear speed sensor.



If the runout is more than the maximum, replace the rear axle hub and bearing assembly.


Hide 42403 5.INSTALL REAR BRAKE DRUM SUB-ASSEMBLY

Hide 6.INSTALL REAR WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)

Hide 7.INSPECT AND ADJUST PARKING BRAKE LEVER TRAVEL