1.INSPECT PARKING BRAKE LEVER TRAVEL
Slowly pull the parking brake lever to the fully applied position, counting the number of clicks.
| Rear Brake Type | Number of Clicks |
|---|---|
| Drum | 8 to 11 |
| Disc | 4 to 7 |
2.ADJUST PARKING BRAKE LEVER TRAVEL (for Rear Drum Brake)
for Separate Type:
Remove the rear console box assembly.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>REAR CONSOLE BOX(for Separate Type)>REMOVAL
for Integrated Type:
Remove the rear console box assembly.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>REAR CONSOLE BOX(for Integrated Type)>REMOVAL
Remove the shoe adjusting hole plug.
|
Expand |
Turn the adjuster to expand the brake shoe until the drum locks.
|
Contract |
Hold the automatic adjust lever away from the adjuster, and contract the brake shoe by turning the adjust bolt using another screwdriver until the drum can rotate smoothly.
12 notches
Check that there is no brake drag against the brake shoe.
| *1 | Lock Nut |
Turn the lock nut until the parking brake lever travel is corrected to within the specified range.
8 to 11 clicks
If the lock nut has been removed from the rod, replace the lock nut with a new one.
Operate the parking brake lever 3 to 4 times, and check the parking brake lever travel.
for Separate Type:
Install the rear console box assembly.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>REAR CONSOLE BOX(for Separate Type)>INSTALLATION
for Integrated Type:
Install the rear console box assembly.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>REAR CONSOLE BOX(for Integrated Type)>INSTALLATION
3.ADJUST PARKING BRAKE LEVER TRAVEL (for Rear Disc Brake)
for Separate Type:
Remove the rear console box assembly.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>REAR CONSOLE BOX(for Separate Type)>REMOVAL
for Integrated Type:
Remove the rear console box assembly.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>REAR CONSOLE BOX(for Integrated Type)>REMOVAL
| *1 | Lock Nut |
Turn the lock nut until the parking brake lever travel is corrected to within the specified range.
4 to 7 clicks
If the lock nut has been removed from the rod, replace the lock nut with a new one.
Operate the parking brake lever 3 to 4 times, and check the parking brake lever travel.
Check whether the parking brake drags or not.
| *a | Stopper |
| *b | Operation Lever |
Release the parking brake lever and check that the clearance measurement between the rear disc brake cylinder operation lever and stopper is within the specified range.
0 to 0.5 mm (0 to 0.0196 in.)
for Separate Type:
Install the rear console box assembly.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>REAR CONSOLE BOX(for Separate Type)>INSTALLATION
for Integrated Type:
Install the rear console box assembly.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>REAR CONSOLE BOX(for Integrated Type)>INSTALLATION
4.INSPECT BRAKE WARNING LIGHT
When operating the parking brake lever, check that the brake warning light illuminates.
Brake warning light always illuminates at the first click.