Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENTRY LOCK AND UNLOCK SWITCH › from 2018.01
RM30M0E _58 Vehicle Interior _017111 THEFT DETERRENT / KEYLESS ENTRY _0087439 ENTRY LOCK AND UNLOCK SWITCH A

THEFT DETERRENT / KEYLESS ENTRY  ENTRY LOCK AND UNLOCK SWITCH  REMOVAL  


CAUTION / NOTICE / HINT

HINT:

The procedure described below is for the LH side. Use the same procedure for both the LH and RH side, unless otherwise specified.


PROCEDURE

Hide 67492A 1.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH

Hide 74220 2.REMOVE FRONT ARMREST ASSEMBLY LH

Hide 74232 3.REMOVE FRONT ARMREST BASE UPPER PANEL LH

Hide 67602 4.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 67832 5.REMOVE FRONT DOOR SERVICE HOLE COVER LH

Hide 69217D 6.REMOVE FRONT DOOR OUTSIDE HANDLE COVER LH

a.
B488401C02
2.479,1.917 2.813,1.917 false 2.281,1.813 2.594,1.969 0.313,0.156 10 false *1
*1 Hole Plug


Remove the hole plug.


b.

Using a T30 "TORX" socket wrench, loosen the screw.


c.

Remove the front door outside handle cover LH with lock cylinder.


Hide 69220 7.REMOVE FRONT DOOR OUTSIDE HANDLE ASSEMBLY LH

a.
B487997C03
2.052,1.469 1.438,1.292 true 2.115,1.385 2.427,1.583 0.313,0.198 10 false *a
*a Protective Tape


Using a screwdriver with its tip wrapped in protective tape, disengage the claws to open the cover as shown in the illustration.


b.
B487998C02
2.302,1.385 1.594,1.177 true 2.375,1.313 2.688,1.51 0.313,0.198 10 false *a
*a Protective Tape


Using a screwdriver with its tip wrapped in protective tape, disconnect the connector.


c.
B487999

Remove the front door outside handle assembly in the direction indicated by the arrow as shown in the illustration.