Home › Vehicle Exterior › LIGHTING (EXT) › LICENSE PLATE LIGHT ASSEMBLY(for Sedan) › from 2018.01
RM30M0E _59 Vehicle Exterior _017126 LIGHTING (EXT) _0092614 LICENSE PLATE LIGHT ASSEMBLY(for Sedan) A

LIGHTING (EXT)  LICENSE PLATE LIGHT ASSEMBLY(for Sedan)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure described below is for the LH side.

·

The license plate light bulb can be replaced by removing only the license plate light lens. It is not necessary to remove the license plate light assembly.



PROCEDURE

Hide 76801A 1.REMOVE LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH SUB-ASSEMBLY

Hide 81270 2.REMOVE LICENSE PLATE LIGHT ASSEMBLY

a.
B505842

Disconnect the connector.


b.
B505843

Disengage the claw and guide to remove the license plate light assembly.


Hide 81274B 3.REMOVE LICENSE PLATE LIGHT PACKING

a.
B505844

Remove the license plate light packing.

NOTICE:

Do not reuse the removed packing. Be sure to install a new license plate light packing to prevent water ingress.



Hide 81271 4.REMOVE LICENSE PLATE LIGHT LENS

a.
B505845

Turn the license plate light housing with the license plate light bulb as shown in the illustration to remove the license plate light lens.


Hide 81270B 5.REMOVE LICENSE PLATE LIGHT BULB

a.
B505846

Remove the license plate light bulb from the license plate light housing.