In this circuit, the combination meter assembly receives engine coolant temperature signals from the ECM using the CAN communication system (CAN V Bus). The combination meter assembly displays engine coolant temperature that is calculated based on the data received from the ECM.
When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
If there is an open or short in the engine coolant temperature sensor circuit, the ECM stores DTCs. Troubleshoot the SFI system.
for 1NR-FE
Click hereEngine / Hybrid System>1NR-FE ENGINE CONTROL>SFI SYSTEM>DTC CHECK / CLEAR
for 2NR-FE
Click hereEngine / Hybrid System>2NR-FE ENGINE CONTROL>SFI SYSTEM>DTC CHECK / CLEAR
Check if CAN communication DTCs are output.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM
| Result | Proceed to |
|---|---|
| CAN communication DTCs are not output. | A |
| CAN communication DTCs are output. | B |
A
B
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Combination Meter / Active Test.
According to the display on the GTS, perform the Active Test.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Indicat. Lamp Coolant Cool | Water temperature cool indicator light | OFF or ON | - |
| Indicat. Lamp Coolant Hot | Water temperature hot warning light | OFF or ON | - |
| Tester Display |
|---|
| Indicat. Lamp Coolant Cool |
| Tester Display |
|---|
| Indicat. Lamp Coolant Hot |
Value selected during Active Test is displayed.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Combination Meter / Data List
According to the display on the GTS, read the Data List.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Coolant Temperature | Engine coolant temperature | Min.: 0°C (32°F), Max.: 127.5°C (261.5°F) | 75 to 100°C (167 to 212°F): After warming up | - |
| Tester Display |
|---|
| Coolant Temperature |
Vehicle's coolant temperature and tester value are the same.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check if SFI system DTCs are output.
for 1NR-FE
Click hereEngine / Hybrid System>1NR-FE ENGINE CONTROL>SFI SYSTEM>DTC CHECK / CLEAR
for 2NR-FE
Click hereEngine / Hybrid System>2NR-FE ENGINE CONTROL>SFI SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| SFI system DTCs are not output. | A |
| SFI system DTCs are output. (for 1NR-FE) | B |
| SFI system DTCs are output. (for 2NR-FE) | C |
A
B
Click hereEngine / Hybrid System>1NR-FE ENGINE CONTROL>SFI SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
C
Click hereEngine / Hybrid System>2NR-FE ENGINE CONTROL>SFI SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING