75129B
1.INSTALL REAR LICENSE PLATE CUSHION
Clean the vehicle installation surface.
Remove the release paper from a new rear license plate cushion.
| *a | Mark Position |
Install the 2 rear license plate cushions as shown in the illustration.
Press the 2 rear license plate cushions.
75444
2.INSTALL NO. 4 LUGGAGE COMPARTMENT DOOR PLATE (w/ Grade Mark)
3.INSTALL NO. 3 BACK DOOR NAME PLATE (for 2NR-FE)
75442
4.INSTALL NO. 2 LUGGAGE COMPARTMENT DOOR NAME PLATE
75441A
5.INSTALL NO. 1 LUGGAGE COMPARTMENT DOOR NAME PLATE (w/ Brand Name Plate)
75431
6.INSTALL LUGGAGE COMPARTMENT DOOR EMBLEM
81270
7.INSTALL LICENSE PLATE LIGHT ASSEMBLY
84945
8.INSTALL LUGGAGE ELECTRICAL KEY SWITCH (w/ Smart Entry and Start System)
76801A
9.INSTALL LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH SUB-ASSEMBLY
81590A
10.INSTALL REAR LIGHT ASSEMBLY LH
81580D
11.INSTALL REAR LIGHT ASSEMBLY RH
Use the same procedure as for the LH side.
69561A
12.INSTALL LUGGAGE COMPARTMENT LOCK CYLINDER RETAINER (w/ Lock Cylinder)
Engage the claws to install the back door lock cylinder retainer as shown in the illustration.
13.INSTALL LUGGAGE COMPARTMENT DOOR LOCK CYLINDER ASSEMBLY (w/ Lock Cylinder)
Install the luggage compartment door lock cylinder assembly with the 2 nuts.
Engage the guide to connect the luggage door lock control cable sub-assembly.
64610
14.INSTALL LUGGAGE COMPARTMENT DOOR LOCK ASSEMBLY (w/ Lock Cylinder)
64610
15.INSTALL LUGGAGE COMPARTMENT DOOR LOCK ASSEMBLY (w/o Lock Cylinder)
64719A
16.INSTALL LUGGAGE COMPARTMENT DOOR COVER
Install the luggage compartment door cover with the 12 clips.