Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › STEERING ANGLE SENSOR › from 2018.01
RM30M0E _54 Brake _017098 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0262396 STEERING ANGLE SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  STEERING ANGLE SENSOR  INSTALLATION  


PROCEDURE

Hide 84306 1.INSTALL SPIRAL CABLE SUB-ASSEMBLY

Hide 2.INSTALL STEERING SENSOR

a.
C381049C01
2.354,1.229 1.885,0.948 1.885,0.948 2.333,0.729 true 2.802,0.906 3.167,0.521 true 0.281,0.542 0.615,0.896 true 2.063,0.438 2.375,0.563 true 1.688,0.865 2,1.021 0.313,0.156 10 false *a 3.198,0.396 3.427,0.604 0.229,0.208 10 false *b 1.896,0.333 2.208,0.49 0.313,0.156 10 false *c 0.104,0.438 0.333,0.646 0.229,0.208 10 false *b
*a Guide
*b Pin
*c Lock Pin


Align the 2 pins and 2 guides, and engage the 6 claws to install the steering sensor to the spiral cable sub-assembly.

NOTICE:
·

Do not remove the lock pin before the steering sensor is installed to the spiral cable sub-assembly.

·

Do not damage the pins of the spiral cable sub-assembly or guides of the steering sensor.

·

The spiral cable sub-assembly can be rotated up to 30° even when the interlock is engaged. Therefore, make sure that both guides are aligned properly when installing the steering sensor to the spiral cable sub-assembly.




b.
C381050

Remove the lock pin from the steering sensor.