Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL(for RHD) › from 2018.01
RM30M0E _54 Brake _017099 BRAKE SYSTEM (OTHER) _0092763 BRAKE PEDAL(for RHD) A

BRAKE SYSTEM (OTHER)  BRAKE PEDAL(for RHD)  REMOVAL  


PROCEDURE

Hide 55302A 1.REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY

Hide 84340 2.REMOVE STOP LIGHT SWITCH ASSEMBLY

Hide 84345 3.REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER

a.
C282210

Remove the stop light switch mounting adjuster from the brake pedal support sub-assembly.


Hide 4.SEPARATE WIRE HARNESS

a.
C285133

Disengage the 2 wire harness clamps.


b.

Disconnect the accelerator pedal sensor assembly connector.


Hide 47101A 5.REMOVE BRAKE PEDAL RETURN SPRING

a.
C285131

Remove the brake pedal return spring from the brake pedal support sub-assembly and push rod pin.


Hide 47264D 6.SEPARATE BRAKE MASTER CYLINDER PUSH ROD CLEVIS

a.
C285132

Remove the clip and push rod pin to separate the brake master cylinder push rod clevis from the brake pedal sub-assembly.


Hide 55106 7.REMOVE BRAKE PEDAL SUPPORT SUB-ASSEMBLY

a.
C381051

Remove the bolt to separate the brake pedal support sub-assembly from the instrument panel reinforcement.


b.
C282213

Remove the 4 nuts and brake pedal support sub-assembly from the body.