The ECM turns on the cruise control indicator by sending indicator output demand signals to the combination meter assembly using CAN communication.
The cruise control indicator illuminates in green when the cruise control system has been turned on using the ON-OFF switch. If a malfunction is detected, the cruise control indicator changes to amber.
The cruise control indicator circuit uses CAN communication. If the cruise control indicator is not functioning correctly, check for CAN communication DTCs before troubleshooting this circuit.
| Result | Proceed to |
|---|---|
| for TFT Display Type | A |
| for Segment Display Type | B |
A
B
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Combination Meter / Active Test.
Check the cruise control indicator by performing the Active Test.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Meter Display 1 | Multi-information display | OFF, 6 to 0 or All | - |
| Meter Display 2 | Multi-information display | OFF, 9 to 7 | - |
| Tester Display |
|---|
| Meter Display 1 |
| Tester Display |
|---|
| Meter Display 2 |
The multi-information display in the combination meter assembly turns off or completely on according to the GTS operation.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Combination Meter / Active Test.
Check the cruise control indicator by performing the Active Test.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Indicat. Lamp Cruise | Cruise control indicator | Cruise control indicator ON / OFF | - |
| Cruise Indicator | Cruise control indicator | Cruise control indicator ON / OFF | - |
| Tester Display |
|---|
| Indicat. Lamp Cruise |
| Tester Display |
|---|
| Cruise Indicator |
The cruise control indicator goes on or off.
| Proceed to |
|---|
| OK |
| NG |
OK
NG