The power steering ECU assembly supplies a voltage of 5 V to the torque sensor (electric power steering column sub-assembly) and monitors the voltage value of the Hall IC inside the torque sensor (electric power steering column sub-assembly) which changes in response to changes in the magnetic flux density (steering torque) detected by the Hall IC, and calculates the assist torque.
While DTC C1514 is detected, power assist is stopped due to fail-safe operation.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Warning Indicate | Return-to-normal Condition | Note |
|---|---|---|---|---|---|---|
| C1514 | Torque Sensor Power Supply Voltage | Diagnosis Condition: IG ON
Malfunction Status: TRQV voltage is less than 4.5 V or more than 5.5 V. |
·
Torque sensor (Electric power steering column sub-assembly) ·
Power steering ECU assembly |
EPS warning light: Comes on | Ignition switch ON again | - |
If the electric power steering column sub-assembly has been replaced, perform torque sensor zero point calibration.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION
If the power steering ECU assembly has been replaced, perform assist map writing and torque sensor zero point calibration.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION
Disconnect the z5 power steering ECU assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| z5-8 (TRQV) - Body ground | Always | 10 kΩ or higher |
| z5-8 (TRQV) - z5-2 (TRQG) | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Start the engine.
| *a | Component with harness connected
(Power Steering ECU Assembly) |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| z5-8 (TRQV) - z5-2 (TRQG) | Engine start | 4.5 to 5.5 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG