Home › Engine / Hybrid System › 1NR-FE INTAKE / EXHAUST › EXHAUST MANIFOLD › from 2018.01
RM30M0E _51 Engine / Hybrid System _053550 1NR-FE INTAKE / EXHAUST _0260000 EXHAUST MANIFOLD A

1NR-FE INTAKE / EXHAUST  EXHAUST MANIFOLD  REMOVAL  


PROCEDURE

Hide 27020 1.REMOVE GENERATOR WITH REGULATOR ASSEMBLY

Hide 89467B 3.REMOVE AIR FUEL RATIO SENSOR

Hide 17168 4.REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR

a.
A313689

Remove the 3 bolts and No. 2 exhaust manifold heat insulator from the exhaust manifold converter sub-assembly.


Hide 17410 5.DISCONNECT FRONT EXHAUST PIPE ASSEMBLY

a.
A383258C01
0.24,0.208 0.5,0.417 0.26,0.208 12 true *A 0.229,2.5 0.5,2.719 0.271,0.219 12 true *B
*A for CVT
*B for Manual Transaxle


Disconnect the heated oxygen sensor connector.


b.

Disengage the clamp to disconnect the heated oxygen sensor wire from the wire harness clamp bracket.


c.

Remove the 2 bolts and 2 compression springs to disconnect the front exhaust pipe assembly from the exhaust manifold converter sub-assembly.


Hide 17118 6.REMOVE MANIFOLD STAY

a.
A313691

Remove the bolt, nut and manifold stay from the exhaust manifold converter sub-assembly and cylinder block sub-assembly.


Hide 25051 7.REMOVE EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY

a.
A313692

Remove the 5 nuts and exhaust manifold converter sub-assembly from the cylinder head sub-assembly.


b.
A313693

Remove the exhaust manifold to head gasket from the cylinder head sub-assembly.


c.

Remove the exhaust pipe gasket from the exhaust manifold converter sub-assembly.