Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
1.REMOVE REAR WHEEL
58910C
2.REMOVE REAR CONSOLE BOX ASSEMBLY
3.LOOSEN PARKING BRAKE CABLE
46430
4.SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY
5.SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY
Remove the 2 bolts and separate the rear disc brake caliper assembly from the rear axle beam assembly.
Hang the rear disc brake caliper assembly using a piece of string or the equivalent.
42431
6.REMOVE REAR DISC
42312E
7.REMOVE REAR AXLE HUB BOLT
| *a | Service Nut |
| *b | Turn |
| *c | Hold |
Temporarily install the 2 service nuts to the 2 rear axle hub bolts as shown in the illustration.
| Thread Diameter | Thread Pitch |
|---|---|
| 12.0 mm (0.472 in.) | 1.5 mm (0.0591 in.) |
Install the service nuts to prevent damage to the rear axle hub bolts.
Using SST and a screwdriver or the equivalent to hold the rear axle hub and bearing assembly, remove the rear axle hub bolt.
42312E
8.INSTALL REAR AXLE HUB BOLT
Temporarily install a new rear axle hub bolt to the rear axle hub and bearing assembly.
| *a | Washer |
| *b | Service Nut |
| *c | Hold |
| *d | Turn |
Install a washer and service nut to the rear axle hub bolt as shown in the illustration.
| Thread Diameter | Thread Pitch |
|---|---|
| 12.0 mm (0.472 in.) | 1.5 mm (0.0591 in.) |
Recommended thickness of the washer is 5 mm (0.197 in.) or more.
Using a screwdriver or the equivalent to hold the rear axle hub and bearing assembly, install the rear axle hub bolt by tightening the service nut.
42431
9.INSTALL REAR DISC
10.INSTALL REAR DISC BRAKE CALIPER ASSEMBLY
Install the rear disc brake caliper assembly to the rear axle beam assembly with the 2 bolts.
46430
11.INSTALL NO. 3 PARKING BRAKE CABLE ASSEMBLY
12.INSTALL REAR WHEEL
13.INSPECT AND ADJUST PARKING BRAKE LEVER TRAVEL
58910C
14.INSTALL REAR CONSOLE BOX ASSEMBLY