The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the front axle hub sub-assembly on-vehicle inspection are shown below.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
The following procedure is for the LH side.
Use the same procedure for the RH side and LH side.
1. PRECAUTION (for HV Model)
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
2.DISABLE BRAKE CONTROL (for HV Model)
Click hereBrake>BRAKE (FRONT)>FRONT BRAKE>REMOVAL
3.REMOVE FRONT WHEEL
4.SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY
43512
5.REMOVE FRONT DISC
Click hereBrake>BRAKE (FRONT)>FRONT BRAKE>REMOVAL
6.INSPECT FRONT AXLE HUB BEARING LOOSENESS
Using a dial indicator with magnetic base, check for looseness near the center of the front axle hub sub-assembly.
0.05 mm (0.00196 in.)
Ensure that the dial indicator is set perpendicular to the measurement surface.
Keep the magnet of the dial indicator away from the front axle hub sub-assembly and front speed sensor.
If the looseness exceeds the maximum, replace the front axle hub sub-assembly.
7.INSPECT FRONT AXLE HUB RUNOUT
Using a dial indicator with magnetic base, check for runout on the surface of the front axle hub sub-assembly outside the front axle hub bolts.
0.05 mm (0.00196 in.)
Ensure that the dial indicator is set perpendicular to the measurement surface.
Make sure to set the tip of the dial indicator towards the outside of the front axle hub bolts.
Keep the magnet of the dial indicator away from the front axle hub sub-assembly and front speed sensor.
If the runout exceeds the maximum, replace the front axle hub sub-assembly.
43512
8.INSTALL FRONT DISC
9.INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY
10.INSTALL FRONT WHEEL
11.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL (for HV Model)
12. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL (for HV Model)
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART