Home › Engine / Hybrid System › M15A-FKS (INTAKE / EXHAUST) › INTAKE MANIFOLD
RM36W0E _51 Engine / Hybrid System _088539 M15A-FKS INTAKE / EXHAUST _0421793 INTAKE MANIFOLD A

M15A-FKS INTAKE / EXHAUST  INTAKE MANIFOLD  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during intake manifold removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Cleaning the deposits from the throttle body with motor assembly Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

NOTICE:

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 22030 1.REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY

Hide 25860 2.REMOVE PURGE VALVE (PURGE VSV)

Hide 23820 3.DISCONNECT FUEL VAPOR FEED HOSE ASSEMBLY

a.
A463696

Disengage the clamp to disconnect the fuel vapor feed hose assembly from the intake manifold.


Hide 23826 4.DISCONNECT NO. 1 FUEL VAPOR FEED HOSE

a.
A463697

Disconnect the No. 1 fuel vapor feed hose from the intake manifold.


Hide 25601 5.REMOVE NO. 1 EGR PIPE SUB-ASSEMBLY

a.
A463698

Disconnect the EGR valve assembly connector.


b.

Disengage the clamp to disconnect the engine wire.


c.
A463699

Using an 8 mm socket wrench, remove the 4 bolts and No. 1 EGR pipe sub-assembly from the intake manifold and EGR valve assembly.


d.
A463700

Remove the EGR valve adapter gasket from the No. 1 EGR pipe sub-assembly.


e.
A463701

Remove the EGR inlet gasket from the intake manifold.


Hide 89421 6.REMOVE E.F.I. VACUUM SENSOR ASSEMBLY (MANIFOLD ABSOLUTE PRESSURE SENSOR)

Hide 82121 7.DISCONNECT ENGINE WIRE

a.
A463702

Disconnect the 2 connectors.


b.

Remove the 3 bolts.


c.

Disengage the 5 clamps and disconnect the engine wire.


Hide 17111 8.REMOVE INTAKE MANIFOLD

a.

w/ Stud Bolt:

i.
A463703

Remove the 3 bolts and 2 nuts.


ii.
A463704

Using an E8 "TORX" socket wrench, remove the 2 stud bolts and intake manifold from the cylinder head sub-assembly.



b.

w/o Stud Bolt:

i.
A463705

Remove the 5 bolts and intake manifold from the cylinder head sub-assembly.



Hide 17177 9.REMOVE NO. 1 INTAKE MANIFOLD TO HEAD GASKET

a.
A463706

Remove the No. 1 intake manifold to head gasket from the intake manifold.


Hide 10.REMOVE VACUUM HOSE

a.
A463332

Remove the vacuum hose from the intake manifold.