The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during throttle body with motor assembly removal/installation are shown below.
51451A
1.REMOVE CENTER ENGINE UNDER COVER
2.DRAIN ENGINE COOLANT
17881
3.REMOVE NO. 1 AIR CLEANER HOSE
| *1 | No. 2 Ventilation Hose |
| *2 | Hose Clip |
| *3 | Hose Clamp |
Slide the hose clip to disconnect the No. 2 ventilation hose from the cylinder head cover sub-assembly.
Loosen the 2 hose clamps to remove the No.1 air cleaner hose from the throttle body with motor assembly.
22030
4.REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY
Slide the clip and disconnect the No. 8 water by-pass hose from the throttle body with motor assembly.
Slide the clip and disconnect the No. 5 water by-pass hose to remove the throttle body with motor assembly.
Disconnect the throttle body with motor assembly connector.
Using an 8 mm socket wrench, remove the 3 bolts to separate the throttle body with motor assembly from the intake manifold.
If the throttle body with motor assembly has been struck or dropped, replace it.
22271
5.REMOVE THROTTLE BODY GASKET
Remove the throttle body gasket from the intake manifold.