Home › Engine / Hybrid System › M15A-FXE (INTAKE / EXHAUST) › INTAKE MANIFOLD
RM36W0E _51 Engine / Hybrid System _088540 M15A-FXE INTAKE / EXHAUST _0421799 INTAKE MANIFOLD A

M15A-FXE INTAKE / EXHAUST  INTAKE MANIFOLD  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during intake manifold removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Cleaning the deposits from the throttle body with motor assembly Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

NOTICE:

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 22030 1.REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY

Hide 25860 2.REMOVE PURGE VALVE (PURGE VSV)

Hide 23826 3.DISCONNECT NO. 1 FUEL VAPOR FEED HOSE

a.
A463757

Disconnect the No. 1 fuel vapor feed hose from the intake manifold.


Hide 25601 4.REMOVE NO. 1 EGR PIPE SUB-ASSEMBLY

a.
A463758

Disconnect the EGR valve assembly connector.


b.

Disengage the clamp to disconnect the engine wire.


c.
A463759

Using an 8 mm socket wrench, remove the 4 bolts and No. 1 EGR pipe sub-assembly from the intake manifold and EGR valve assembly.


d.
A463760

Remove the EGR valve adapter gasket from the No. 1 EGR pipe sub-assembly.


e.
A463761

Remove the EGR inlet gasket from the intake manifold.


Hide 89421 5.REMOVE E.F.I. VACUUM SENSOR ASSEMBLY (MANIFOLD ABSOLUTE PRESSURE SENSOR)

Hide 82121 6.DISCONNECT ENGINE WIRE

a.
A463762

Disconnect the connector.


b.

Remove the 3 bolts.


c.

Disengage the 3 clamps and disconnect the engine wire.


Hide 17111 7.REMOVE INTAKE MANIFOLD

a.
A463763

Remove the 4 bolts and 2 nuts.


b.
A463764

Using an E8 "TORX" socket wrench, remove the 2 stud bolts, No. 2 fuel delivery guard and intake manifold from the cylinder head sub-assembly.


Hide 17177 8.REMOVE NO. 1 INTAKE MANIFOLD TO HEAD GASKET

a.
A463765

Remove the No. 1 intake manifold to head gasket from the intake manifold.


Hide 9.REMOVE VACUUM HOSE

a.
A463766

Remove the vacuum hose from the intake manifold.