After replacing the airbag sensor assembly, make sure to perform ECU configuration.
After performing the ECU configuration procedure, make sure to perform the initialization procedure for when the cable has been disconnected and reconnected to the negative (-) auxiliary battery terminal.
89170
1.INSTALL AIRBAG SENSOR ASSEMBLY
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
temporarily install the airbag sensor assembly with the 3 bolts.
Install the 3 bolts in the order shown in the illustration.
If the airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.
When installing the airbag sensor assembly, make sure that the SRS wiring does not interfere with or is not pinched between other parts.
When the ignition switch is first turned ON after the airbag sensor assembly has been replaced, make sure that no one is in the vehicle.
|
Push in the Lock Lever |
Connect the 2 connectors and push in the lock lever to lock the 2 connectors.
When connecting any airbag connector, take care not to damage the airbag wire harness.
Check that there is no looseness in the installed parts of the airbag sensor assembly.
58510D
2.CONNECT FRONT FLOOR CARPET ASSEMBLY
Engage the hooks to connect the front floor carpet assembly as shown in the illustration.
|
Connect in this Direction | - | - |
Install the 2 clips.
58910C
3.INSTALL REAR CONSOLE BOX ASSEMBLY
4.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
for Gasoline Model:
Click hereGeneral>MAINTENANCE>M15A-FKS AUXILIARY BATTERY>INSTALLATION
for HV Model:
Click hereGeneral>MAINTENANCE>M15A-FXE AUXILIARY BATTERY>INSTALLATION
5. UPDATE ECU SECURITY KEY
6. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
7. PERFORM DIAGNOSTIC SYSTEM CHECK
8.INSPECT SRS WARNING LIGHT
9. ZERO POINT CALIBRATION
When the airbag sensor assembly is replaced, perform zero point calibration.
Click hereGeneral>SETUP>WHEN REPLACING OR REMOVING/INSTALLING PARTS>WORK PROCEDURE