Home › Engine / Hybrid System › M15A-FXE (COOLING) › WATER PUMP
RM36W0E _51 Engine / Hybrid System _088542 M15A-FXE COOLING _0421976 WATER PUMP A

M15A-FXE COOLING  WATER PUMP  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the engine water pump assembly (water inlet housing) removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Cleaning the deposits from the throttle body with motor assembly Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

PROCEDURE

Hide 16031 1.REMOVE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY

Hide 16032 2.REMOVE ENGINE WATER PUMP ASSEMBLY (WATER INLET HOUSING)

a.
A465273

Remove the 4 bolts and engine water pump assembly (water inlet housing) from the cylinder block sub-assembly.


b.
A465274

Remove the gasket from the engine water pump assembly (water inlet housing).