Home › Engine / Hybrid System › M15A-FXE (COOLING) › THERMOSTAT
RM36W0E _51 Engine / Hybrid System _088542 M15A-FXE COOLING _0421977 THERMOSTAT A

M15A-FXE COOLING  THERMOSTAT  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the water inlet with thermostat sub-assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Cleaning the deposits from the throttle body with motor assembly Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

NOTICE:

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 51451A 1.REMOVE CENTER ENGINE UNDER COVER

Hide 2.DRAIN ENGINE COOLANT (for Engine)

Hide 16572D 4.DISCONNECT NO. 2 RADIATOR HOSE

a.
A465276

Slide the clip and disconnect the No. 2 radiator hose from the water inlet with thermostat sub-assembly.


Hide 16031 5.REMOVE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY

a.
A465277

Disconnect the engine water pump assembly (water inlet housing) connector.


b.

Using an 8 mm socket wrench, remove the bolt and disconnect the bracket from the engine water pump assembly (water inlet housing).


c.
A465278

Slide the clip and disconnect the No. 6 water by-pass hose from the water inlet with thermostat sub-assembly.

NOTICE:
·

Do not apply force to the water inlet with thermostat sub-assembly when disconnecting the No. 6 water by-pass hose.

·

Do not damage the water inlet with thermostat sub-assembly.



HINT:

When disconnecting the No. 6 water by-pass hose, slide the clip, rotate the hose and pull it straight off the pipe.



d.
A465279

Using an 8 mm socket wrench, remove the 2 bolts and water inlet with thermostat sub-assembly.


e.
A465280

Remove the gasket from the water inlet with thermostat sub-assembly.