The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the spiral cable with sensor sub-assembly removal/installation are shown below.
Be sure to read precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is operated normally
45130
1.REMOVE HORN BUTTON ASSEMBLY
45100
2.REMOVE STEERING WHEEL ASSEMBLY
84306
3.INSPECT SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
Check that the front wheels are facing straight ahead.
Check that the spiral cable with sensor sub-assembly is center position.
The connector is at the top.
The colored roller or the top of the flat cable U-turn can be checked from the check window.
| *A | Colored Roller (Visible Type) | *B | Flat Cable (Visible Type) |
| *a | Check Window | *b | Colored Roller |
| *c | Top of Flat Cable U-turn | - | - |
If the result is not as specified, it is possible that the spiral cable sub-assembly is broken. Replace the spiral cable sub-assembly with a new one.
45287
4.REMOVE LOWER STEERING COLUMN COVER
45286B
5.REMOVE UPPER STEERING COLUMN COVER
84306
6.REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
Do not replace the spiral cable with sensor sub-assembly with the battery connected and the ignition switch on (IG).
Do not rotate the spiral cable with sensor sub-assembly with the battery connected and the ignition switch on (IG).
When rotating the spiral cable with sensor sub-assembly to check the operation of the spiral cable with sensor sub-assembly (checking for abnormal noise, checking the Data List, etc.), make sure to perform the inspection with the steering wheel assembly installed.
Disconnect each connector.
When disconnecting any airbag connector, take care not to damage the airbag wire harness.
Refer to How to Connect or Disconnect Airbag Connector: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR
Disengage the claw and clips to remove the spiral cable with sensor sub-assembly.
89245B
7.REMOVE STEERING SENSOR
Remove the steering sensor from the spiral cable sub-assembly only when replacing the spiral cable sub-assembly.
Removing the steering sensor from the spiral cable sub-assembly without using a lock pin may result in a misaligned center position of the steering sensor. Therefore, make sure to use the lock pin provided with a new spiral cable when removing the steering sensor from the spiral cable sub-assembly.
Install the lock pin to the steering sensor.
Use the lock pin provided with a new spiral cable.
Do not remove the lock pin before the spiral cable is installed to the steering sensor.
Disengage the claws and guides to remove the steering sensor from the spiral cable sub-assembly.