Home › Steering › STEERING COLUMN › STEERING WHEEL › 2020.03–2020.07
RM36W0E _55 Steering _087550 STEERING COLUMN _0424131 STEERING WHEEL A

STEERING COLUMN  STEERING WHEEL  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the steering wheel assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point Parking assist monitor system (Click here)

HINT:

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 2. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

Hide 45130 3.REMOVE HORN BUTTON ASSEMBLY

Hide 45100 4.REMOVE STEERING WHEEL ASSEMBLY

a.

Disconnect each connector.


b.
C434139C01
1.99,0.781 2.396,0.615 2.396,0.615 1.99,0.667 true 2.427,0.5 2.625,0.688 0.198,0.188 10 true *a
*a Matchmark


Using a 10 mm hexagon socket wrench, remove the steering wheel assembly set bolt.


c.

Put matchmarks on the steering wheel assembly and steering main shaft.


d.

Temporarily install the steering wheel assembly set bolt.

NOTICE:

Do not overtighten the steering wheel assembly set bolt.



e.
C434140C01
1.323,0.688 2.396,0.688 true 1.844,1.156 2.396,1.156 true 2.438,0.594 2.76,0.833 0.323,0.24 10 false SST 0.979,3.031 1.177,3.198 0.198,0.167 10 false *b 2.281,3.021 2.479,3.188 0.198,0.167 10 false *a 2.448,1.063 2.771,1.302 0.323,0.24 10 false SST
*a Turn
*b Hold


Using SST, separate the steering wheel assembly.

SST
09950-50013  (09951-05010, 09952-05010, 09953-05020, 09954-05031, 09957-04010)
09950-60011  (09951-00330)

NOTICE:

Apply a small amount of grease to the threads and tip of SST (09953-05020) before use.



f.

Remove the steering wheel assembly set bolt and steering wheel assembly.


Hide 45116 5.REMOVE NO. 1 STEERING WHEEL ORNAMENT

Hide 84250A 6.REMOVE STEERING PAD SWITCH ASSEMBLY

Hide 7.REMOVE SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY) (w/ Shift Paddle Switch)