The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during transmission control cable assembly removal/installation are shown below.
To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.
When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is operated normally
1.SECURE VEHICLE
Fully apply the parking brake and chock a wheel.
Make sure to apply the parking brake and chock a wheel before performing this procedure.
If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.
G9200
2.REMOVE INVERTER WITH CONVERTER ASSEMBLY
51451A
3.REMOVE CENTER ENGINE UNDER COVER
51447D
4.REMOVE CENTER NO. 4 ENGINE UNDER COVER
17410
5.REMOVE FRONT EXHAUST PIPE ASSEMBLY
58151
6.REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
Remove nut and front No. 1 floor heat insulator from the vehicle body.
58153
7.REMOVE FRONT NO. 2 FLOOR HEAT INSULATOR
Remove 4 nuts and front No. 2 floor heat insulator from the vehicle body.
58910C
8.REMOVE REAR CONSOLE BOX ASSEMBLY
33820B
9.REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY
Move the shift lever to N.
Disconnect the transmission control cable assembly from the transmission floor shift assembly.
| *1 | Lock Nut |
| *a | Counterclockwise |
Rotate the lock nut counterclockwise approximately 180° and, while holding the lock nut in that position, disconnect the transmission control cable assembly from the transmission floor shift assembly.
Remove the nut to disconnect the transmission control cable assembly from the control shaft lever.
Remove the clip to disconnect the transmission control cable assembly from the No. 1 transmission control cable bracket.
Disengage the clamp to separate the transmission control cable assembly.
Remove the bolt to disconnect the transmission control cable assembly from the hybrid vehicle transaxle assembly.
Remove the nut.
Disengage the guide to disconnect the transmission control cable assembly from the vehicle body.
Remove the 2 nuts and transmission control cable assembly from the vehicle body.