Home › Drivetrain › K320 (MULTIDRIVE / CVT) › OIL PRESSURE SENSOR
RM36W0E _52 Drivetrain _087836 K320 MULTIDRIVE / CVT _0422062 OIL PRESSURE SENSOR A

K320 MULTIDRIVE / CVT  OIL PRESSURE SENSOR  INSTALLATION  


PROCEDURE

Hide 89637K 1.INSTALL OIL PRESSURE SENSOR

a.
C395505

Coat the O-ring of the oil pressure sensor with Toyota Genuine CVT fluid FE.

NOTICE:

If reusing the oil pressure sensor, check that the O-ring is not damaged.



b.

Using a 27 mm deep socket wrench, install the oil pressure sensor to the rear transaxle case sub-assembly.

Torque:
20.6 N*m (210 kgf*cm, 15 ft.*lbf)

NOTICE:

Be careful not to damage the O-ring.



c.

Connect the oil pressure sensor connector.


Hide 2.INSPECT FOR CONTINUOUSLY VARIABLE TRANSAXLE FLUID LEAK

Hide 51442C 3.INSTALL ENGINE UNDER COVER LH

Hide 51451A 4.INSTALL CENTER ENGINE UNDER COVER

Hide 5.INSTALL FRONT WHEEL LH