Home › Drivetrain › K320 (MULTIDRIVE / CVT) › SHIFT STROKE SENSOR
RM36W0E _52 Drivetrain _087836 K320 MULTIDRIVE / CVT _0422063 SHIFT STROKE SENSOR A

K320 MULTIDRIVE / CVT  SHIFT STROKE SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the shift stroke sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Air intake system parts Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

PROCEDURE

Hide 17705 1.REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE

Hide 17701 2.REMOVE AIR CLEANER CASE SUB-ASSEMBLY

Hide 89419B 3.REMOVE SHIFT STROKE SENSOR

a.
C429224

Disconnect the shift stroke sensor connector.


b.
C429225

Remove the bolt and shift stroke sensor from the transaxle case sub-assembly.